The RIDGID Model 1017, catalog number 31175, is a telescoping basin wrench with a 10-to-17-inch shank and published 3/8-to-1-1/4-inch capacity. It fits mounting nuts the pivoting jaw can seat squarely; it is not the correct tool for every proprietary faucet fastener.
This assessment uses RIDGID’s specifications. It does not claim hands-on torque or access testing.
Map the access path
Shut off the water and clear the cabinet. Measure from the cabinet floor to the mounting nut and look for a disposal, filter, drain trap, braces and supply tubes that could block the shaft or handle. The telescoping shank adds reach but cannot create swing space around an obstruction.
Identify the nut material and shape. Some faucets use a long plastic mounting nut or a maker-specific installation tool. Use the faucet instructions when available instead of assuming a metal-jaw basin wrench is appropriate.
Apply force without damaging the plumbing
Seat the spring-loaded jaw fully on the nut and orient it for the direction of turn described by RIDGID. Support the faucet above so it does not rotate and twist the supply lines. Use controlled hand force; do not add a pipe extension to the handle.
Corroded hardware can break, and a seized nut may need cutting or faucet replacement. Stop if the wrench slips repeatedly, the sink flexes, a valve begins to leak or a rigid tube twists.
After installation, reconnect correctly sized supplies without kinks or side load. Restore water slowly and inspect each connection with dry tissue, then recheck after use.
Buying decision
Choose catalog 31175 when the nut falls within its published capacity and the cabinet provides a straight access path and handle swing. Choose the faucet maker’s tool or another documented wrench when the fastener shape or obstruction prevents full jaw contact.
The Amazon button searches RIDGID 31175. Confirm the catalog number rather than relying on the generic “basin wrench” title.
Primary source: RIDGID basin wrench specifications .